Printing Wallets

[Bob700]

Hi
I've just wasted some wallets, when I print it stll leaves some white marks on one it looked liked creases, I tried it with and without a silicon mat pushed into where the notes go and I used the correct time, heat and pressure recomended by BMS but they are not sellable, does anyone have any tips.

Thanks Bob

[Paul]

i always pre press my for few seconds then print them at 185C 60sec. heavy pressure. never had a problem

[Bob700]

Thanks Paul I'll give it a go, do you put anything in the wallet to lift the printable area

[Paul]

nope. i put my on the edge of my press. only printable bit. re press it and press it with transfer on.

[Bob700]

Good man, I'm inspired again

[Karen.]

I use to place a folded towel under mine when pressing. Just put the flap under the press on the towel. This allows any press studs etc to sink into the towel giving a flatter printable area. High pressure.

[NASH]

i place my printable area under a mousemat and no problems