top to bottom prints on mugs?

[GoonerGary]

[MENTION=8882]Baldy[/MENTION]
The 5013 print up to the top really nicely, but all my 5013s had a deep ridge 5mm from the bottom causing a faded ring around the circumference.
[MENTION=7061]webtrekker[/MENTION]

Oh yes, Jubilee clips would do it! I reckon the inconsistency is a combination of things, but eliminating the buckle should get me closer. Some of my wraps are only half the thickness, so it's probably those ones not holding the mug's weight.

[GoonerGary]

I do that with my mugs, Gary. I stand them on Jubilee clips to stop the bottom edge of the silicone wrap touching the grille as this sometimes causes the edge to wrinkle.

Cracked it. Had a hunt around my hardware store and found some clips and other things which had been lying around the store since the 1960s.

[webtrekker]

Looking good! :biggrin: