Page 1 of 1
Re: Panel size
Posted: 09 Aug 2013, 18:08
by TonyM
Hi all,
Looking to print a black panel mug, cant be wrong as I only have one.
Went on BMS and the sizes cannot be right?
Re: Panel size
Posted: 09 Aug 2013, 18:39
by JMugs
The print area on my template is 84mm by 194mm, but if in doubt just measure it.
[ATTACH=CONFIG]1893[/ATTACH]
They can be stunning though.
Re: Panel size
Posted: 09 Aug 2013, 18:58
by socialgiraffe
Use a piece of masking tape, Wrap it round the mug and mark off the two edges. Add 2-3mm either side.
Re: Panel size
Posted: 09 Aug 2013, 22:29
by JMugs
They can be difficult to print, so don't get stressed if it all goes tits up.
Re: Panel size
Posted: 10 Aug 2013, 09:02
by Andrew
I think they are fairly straight forward to print. Matching black is hit of a pain to make it look good if that is required. Panel sizes vary from supplier though.