3D Vacuum Mini Sub Heating Times

[customprints]

Hi Everyone, I am new to the sublimation printing process. I have invested just over £600 on some new equipment.
Richo SG 3110DN Printer & a box of 36 coffee mugs.

I was watching a youtube video that was showing the process for sublimating 4 11oz coffee cups at a time.
Pre-heat for 2 minutes @ 190c
Then place coffee mugs into draw and heat for 400 seconds.

But this was for four?
What is everyone's experience for printing
a single mug
2 mugs
3 mugs

or is the 400 seconds the default time when printing any quantity at the same time?
Thanks in advance

[Scotty@BMS]

I'd stick with one time regardless, and probably 480 seconds rather than 400.

[customprints]

Thanks @Scotty@BMS - I will give that a go as im flying through ym first bix of mugs like they are going out of fashion.

[Redboxinc]

What temp are you cooking at?