Cameo Driving me up the wall

Bob700 · Post by **Bob700** » 07 Mar 2015, 15:22

Hi
Now that I have the thing cutting more often than not it leaves out a letter on the vinyl. I stay within the perimeters of the red square, I didn't have any of these problem using a Craft Robo with Studio software....any ideas where I may be going wrong

Thanks

NikGrey · Post by **NikGrey** » 07 Mar 2015, 17:17

Downgrade Designer Software to 2.9.45 - I have been through all of these problems too, finally settled on a version which just works.

viccar · Post by **viccar** » 07 Mar 2015, 18:00

Are you using a mat?
If not have you selected load mat instead of load media?

viccar · Post by **viccar** » 07 Mar 2015, 18:01

Bob the best thing to do is have a spare couple of hours and you tube cameo videos, you will learn so much

Bob700 · Post by **Bob700** » 07 Mar 2015, 23:03

Hi Viccar
Yes I think youtube will give me some good videos to study

Cheers Bob

Vynmarius · Post by **Vynmarius** » 11 Mar 2015, 12:51

Where its not cutting the letter, is your adjustable pinch roller going over it?

NikGrey · Post by **NikGrey** » 11 Mar 2015, 19:46

Did you try using the same software version I suggested? I had exactly the same problem - this solved it.

DSF

DSF

Cameo Driving me up the wall

Re: Cameo Driving me up the wall

Re: Cameo Driving me up the wall

Re: Cameo Driving me up the wall

Re: Cameo Driving me up the wall

Re: Cameo Driving me up the wall

Re: Cameo Driving me up the wall

Re: Cameo Driving me up the wall

Who is online