Glass Coaster Problem

[Jollyware]

Hi, I messed up on some glass coasters and was just wondering if it looks like I did not apply enough pressure.

I'm a bit wary about putting to much pressure on with it being glass.

I also put 4 on the press at the same time, is it advisable to do them one by one.

vB_ID:3334

IMG_0149.JPG (72.88 KiB) Viewed 12 times

[Paul]

it looks more like they have not got enough temperature or time.

[Jollyware]

The supplier for these states 190 C for 160 sec (medium pressure) and BMS state 190 C for 120 sec (medium pressure)

I did these for 160 sec and don't really fancy messing the replacements up because it has now eaten my profit

I know it's all a learning curve and was just wondering if anyone else had printed these with success and what their settings were.

[pisquee]

We put as many in the press as we can (to make them economical to print) which for us is 12 coasters on a PressMech
We use a temperature of 200 degrees C, and have them in for 240 seconds, with a firm pressure - they are tempered/toughened glass and I've never had one break in the press, rarely break at all even when dropping them on the cold cobbles of Greenwich Market in London!

E2A - this is with the paper transfers on the bed of the press, facing up, with the printable side of the coaster facing down onto it - so you are heating through the glass, rather than heating the paper/ink directly.

Also, using InkTec Sublinova, results for different inks may vary.

[Jollyware]

That seemed to work better but some of the paper stuck to the glass, maybe I had the pressure to firm.

I did it printable side up.

[pisquee]

That seemed to work better but some of the paper stuck to the glass, maybe I had the pressure to firm. I did it printable side up.

Do it printable side down ... we use semi adhesive sublimation paper and don't have problems with the paper sticking to the coasters.