Ricoh Printer SG3110DN

[Ang]

Well everyone tonight has been a big learning curve for me. Firstly, my Ricoh printer arrived late afternoon so had to get it set up and to be honest i am not a very techie type person. Got the printer set up already had my mugs designs ready, so printed one - heat pressed - low and behold the colours werent right. So after reading lots on here downloaded the power driver. Did another print and the colours looked great - heat pressed - what i hadnt spotted was though that the text had turned itself round - i had already done that on the design, but the printer for whatever reason had turned it again!
So i turned it back on the design and low and behold i now have a good mug!
Now, i bet there are a few out there thinking daft so and so, and other thinking - that was me!!
but how do i get the printer not to reverse the designs? I have always done that myself and would prefer to do so in the future!
Thanks for this forum its a mind of information
regards
Ang

[Skye]

Hi Ang,

On the Powerdriver's preference page the "mirror" check box is usually selected. Switch it off if you want to control the mirroring yourself.

vB_ID:3104

Capture.JPG (65.74 KiB) Viewed 5 times

Karen

[Ang]

Many thanks for your reply, have now found it and turned it off!!