just had wee chat to supplier...Hmmm

[bigj2552]

just off of email to one of our suppliers abroad.....

was asking about 3d machines, prices, specs for import...


i was looking at the one martin was selling @ £660....and wondering why it was going so cheap.....
supplier said "as far as I know that machine will not be available in the market any more"...wonder why they phazing it out ?
either not that good a seller...or it crap....or both

asked her one for film print - she came back with a few...some way, way over the top......

this is one down the mid range end of the scale....but not got lot info on it till tomorrow...

only looks like its does 1 case at time......unless it does it in in under 2 minutes, dont see the point when you got large runs on

see pics - these are for film ONLY.... if it does like 2 cases min, i might be inserted - pending spec and price...these are brand new to the market
[ATTACH=CONFIG]2446[/ATTACH][ATTACH=CONFIG]2447[/ATTACH]

[socialgiraffe]

Looks very interesting BJGJ, although if I am half asleep I may end up pouring coffee in it instead

[bigj2552]

Looks very interesting BJGJ, although if I am half asleep I may end up pouring coffee in it instead

LMAO...just what i was thinking when first seeing it

pends on the size..as pics sizes can be deceiving at there best - hopefully more spec later today / tomorrow....

[pisquee]

Is this made in a factory that also makes deep fat fryers?

[Mattie]

Is this made in a factory that also makes deep fat fryers?

I was thinking that, looks a awful lot like the Philips air fryer

[bigj2552]

lol....

looks can be very deceiving gents

will get spec tomorrow.....
would fit nice with my appliances in the kitchen tho

looks to me to only be doing 1 case at one time....and its film ONLY...

but one case is fine if its like 120sec cooking ( vacuum ) time from start to finish.

from what i heard the new machines dont need cooling jigs, as the cooking temp is a lot lower than normal 3d vacuum sublimation - so...

print then straight out to sell/pack......

but this company have another 3 /4 3d machines they gonna get specs over to us...so will see what come out of it....hopefully a decent priced, decent spec 3d machine for us ...ITS TIME

[Justin]

Looks very interesting but to echo above comments, does look like my chip machine that went back! lol...keep us updated

[Justin]

Could well be based on the same machine bit if it has a vacuum and is film based then why not? I'd expect 6 mins+ print time.

[ATTACH=CONFIG]2448[/ATTACH]

[socialgiraffe]

Stop posting the images guys, you are making me very hungry... LOL!!!!

[bigj2552]

Stop posting the images guys, you are making me very hungry... LOL!!!!

[ATTACH=CONFIG]2449[/ATTACH]

chips with your sub machine sir