how can i stop this

[india]

[ATTACH=CONFIG]1280[/ATTACH]
how can i get this residue off and more importantly how can i stop this happening, what am i doing wrong
thanks x

[Paul]

what is it? flock?
if so what time and temp you used?? if you want some help ou need to give bit more info so folks know what o rule out.

[india]

yes its flock, im using temp 170 for 10 seconds? Its fine in the middle its just all the way round the outside, even when i have trimmed the edges where u can see lots of 'fluff'?thanks for any help anyone can offer
x

[accdave]

I find I get more residue if I peel it off while it's too hot.

[P4UL]

Try different/less pressure......also you can attempt to remove residue with transfer removal spray.

[socialgiraffe]

Your temp settings are fine, just need to make sure you are using medium pressure.

If all else fails and as a workaround you could always insert a sheet of a4 paper up to the edge of the required flock. This means the residue will adhere to the paper and not the garment.... hopefully!

[Paul]

You peel it cold???

[AdamB]

Just a guess but have you tried trimming the edges again after weeding?

I had this once and found that a small bit of residue was left after I had cut out logos to be pressed. I trimmed them closer after I had weeded them and it solved the problem.

(might work?)

Its fine in the middle its just all the way round the outside, even when i have trimmed the edges where u can see lots of 'fluff'?x

Just re-read your post - and noticed you said you trim then again after weeding .................... ummm, puzzling ?