which compressor to use for Secabo TP10

[Garageprint]

Hi all, I've recently bought a Secabo TP10 and its being delivered next week. I was wondering what's the best decently priced/quiet compressor for me to use? I'm mainly going to be using it for chromaluxe panels so what pressures would people normally run it at? any tips welcome!

thanks
Alex

[UK Printed Mugs]

Hi Alex. We have the same TP10 and use Clarke Shhh which is fantastic and has been in use for over five years now without bother - I think I purchased it second hand but new one here https://www.machinemart.co.uk/p/quiet-run-compressor-2

[Garageprint]

Hi Alex. We have the same TP10 and use Clarke Shhh which is fantastic and has been in use for over five years now without bother - I think I purchased it second hand but new one here https://www.machinemart.co.uk/p/quiet-run-compressor-2

great thanks alot! is there any requirements for it i need to look out for? im guessing it needs to be like 8 bar i think i saw someone saying but idk about the capacity needed, i take it 9L with the one above is okay?

[pw66]

So long as it is a quiet model then virtually any compressor will do. There is plenty of time even for a small tank to recharge between sublimation prints. A rubber mat will reduce the noise a bit more.
If you didn't want to spend that much there are plenty of compressors around that run at about 60db for less than £150 (Hyundai, SGS etc). 60db is workable - just avoid the 90db garage compressors.