HI

[PhilDavies]

Hi, although I am new to this forum I'm not new to sublimation. This is the third time spanning 17 years that I have decided to start up again. The first time sublimation equipment was extremely basic, a converted photocopier (the type where the platen with paper on the glass moved across the scanning head) and produced a black only image. Any colour was filled in with special marker type pens!! Mugs etc were just a twinkle in the inventers eye. Of cause the industry has moved on leaps and bounds and it is left to ones imagination now. The heart of my new equipment is a Ricoh GXe3300n printer, thought I would give this a try as my memory is not dimmed enough to remember the amount of times I unblocked the print heads on my Epson A3 printer. I retained my existing mug press (from Nova Chrome) and this still works OK. Clam type heatpress (bought of Ebay) for flatwork and software is CorelDraw and Adobe Photoshop. I also have Mural 8 for tiles which I purchased some years ago. Trouble is I cannot reload it because I do not have the keycode and after extensive emails to the man'f in the USA they have not bothered to reply - ANY SUGGESTIONS PLEASE. I am now looking forward to restarting over the next few months and logging in to DSF

[bms]

Welcome to the forum and good luck with the codes!

[PhilDavies]

Hello Martin, Sounds like you have had experience of them too.

[AJLA]

Hi Phil welcome on board, no doubt you'll have lots of advice to share with us!

[Justin]

Hi Phil and welcome to the forum

Justin
DSF Admin