After more than a year, I finally found my mug press! It was nicely packed in a plastic box with the instructions
This is the press - anyone recognise it?
vB_ID:4050
2016-06-13 18.40.01.jpg (90.11 KiB) Viewed 5 times
In the instructions it tells me to set the temperature to 230degF for mugs and much higher for aluminium water bottles - somewhere near 300 from memory.
When I switch the mug press on, the display reaches 150 and starts beeping. Press the Mode button and I can't raise the temperature any higher than 220deg. I'm left wondering whether my press is set to centigrade and not Fahrenheit!
If someone has any knowledge of this heat press, any instructions, advice or whatever, I'd like to hear from you
Cheers
John
Neoflex Direct to Garment Printer, Brother BAS-463 3 Head Embroidery Machine, Gerber Edge FX & 1, Gerber GS15Plus Plotter, Ricoh GX-7000 GelsPrinter, Adkins BETA Major Pneumatic Press, Graphtec CE5000-60 & Craft Robo, HTP616 Twinhead Mug Press & 2 Halogen Ovens.
It looks similar to mine so if it only adjusts to 220 it is in centigrade I'd try a mug at 180 and see how it goes'I'm not sure if yours is a manual start to the timer but mine has a micro switch on the lever.
looks the same as the one i won from BMS in the good old days of the forum, if it is, then its good Mark my chief presser and bottle washer (husband) uses the 180/180 method ie time temp, if you get stuck pm me and i will get him to call you
[CENTER][h=5]A dictionary is the only place where success comes before work[/h]Laura www.fatmaggot.com
[/CENTER]
