I've printed a could of door hangers but when they cool they warp a little. Noting too bad, but not flat.
Could this be too high temp? Or do I need to cool them a different way?
Door hangers
Re: Door hangers
Something heavy and metal (metal to take out the heat quicker) placed on top right after pressing may help?
.....................................................................................................................................................................................................
Make it idiot proof and someone will make a better idiot. He who laughs last thinks slowest! :tongue:
Make it idiot proof and someone will make a better idiot. He who laughs last thinks slowest! :tongue:
Re: Door hangers
I'll give that ago!scotty44;106517 wrote:Something heavy and metal (metal to take out the heat quicker) placed on top right after pressing may help?
Re: Door hangers
Hong to revisit this soon. Anyone had any other experience of these? Going to try everything.
-
socialgiraffe
- Posts: 4597
- Joined: 16 Jun 2011, 23:40
- Been thanked: 1 time
- Contact:
Re: Door hangers
Not sure which ones you are printing, but I recently did a couple that came from Coralgraph. Followed their pressing guide exactly and was really pleased with the result. Printed on Ricoh using Sawgrass inks and an Atkins press.
Placed them on a cold sheet of glass as soon as I took them off the press.
Sent from my iPhone using Tapatalk
Placed them on a cold sheet of glass as soon as I took them off the press.
Sent from my iPhone using Tapatalk
USING: Whatever it takes to get the job done...
Who is online
Users browsing this forum: No registered users and 1 guest