Printing on to MDF board

[Andysam26467]

Hi all,
l've been asked if I can print on to MDF wood. The size will be approximately 200mm x 200mm and between 3-6mm thick. I do sublimation printing and also vinyl printing. I can't find any MDF blanks this size at all.

Does anyone one know where I cn get the blanks from or how I can put an I age on to MDF. It doesn't have to be sublimation. I didn't know whether there was an ink jet transfer paper that could do this. I'm open to any suggestions.

This is could be quite a big job if I can figure a way to print it. I know it's possible because I've seen printed MDF plaques and the like.

Many thanks in advance

Andy

[kermit]

http://www.thetransferpress.co.uk/unisu ... 2x17039094

[KathG]

I beleive that isub supplies cut a sublimation board to size. Not sure if it MDF or a hard board. It is already coated white for sublimation.

[Andysam26467]

Thanks guys. It looks like The Transfer Press blanks are exactly what I'm looking for.

I checked out I sub supplies and I can only see 600 x 300mm boards but I will contact them tomorrow to se if they do other sizes.

Thanks again