Wallets?

[Scary]

Hi
I've bought some Bagbase wallets, tested one yesterday and the print came out fine but the polyester spine (I pressed it open, not sure if that was right?) went a bit 'melty' has anyone tried these and know what the correct settings are? (I just guessed!) they don't give any info on their website and they are a bit too pricey to keep testing

Thanks!

[Quinsfan]

I press my wallets open but with only the part to be pressed in the press. with the rest hanging outside. Hope that makes sense.

[FutureProject]

yup I press one side, then the other so the spine is always just on the outside of the press

[Scary]

thank you, I done another with the edge hanging over as suggested and some paper taped over the spine just in case and it worked perfectly!