DSF

Hi,

I'm a publisher of a community magazine and looking at getting into printing mugs (for starters) as an add on - it seems like a mine field though

Hi Mug and welcome to the forum

Justin
DSF Admin

Welcome! Good luck with the sublimation journey

Thanks, I'm hoping it's not too tricky

I would say IMHO that you get the same out as you put in so make sure you read up as much as you can and once you have the equipment then start testing and remember that mistakes are not always bad as long as you learn from them

read well and welcome to the forum,enough on here to sink a battleship ,just ask the right questions