DSF

Anyone used or seen these machines? - http://www.meikeda.com/3d-vacuum-sublim ... hines.html

Been offered the big one but it obviously costs a fair bit so not sure. I know the supplier is very good on quality of blanks so not unknown there. Just 3D is a totally new thing for me but might be tempted on this one.

Which one Andrew?

I have one sold by BMS, I have only used it a couple of times (been too busy with other stuff), but it has printed perfectly both times.

The 5060 version I am looking at. Is it the 3030 red one you had? I thought these were the machines that were being supplied over here so that makes me feel a bit better.

The one I have is the VP3030 Classic. Works fine and a small footprint.

Good to hear all's good so far.

so far....

you know it will go wrong once I get my backside in gear and start to look for work for the little blighter