DSF

just off of email to one of our suppliers abroad.....

was asking about 3d machines, prices, specs for import...


i was looking at the one martin was selling @ £660....and wondering why it was going so cheap.....
supplier said "as far as I know that machine will not be available in the market any more"...wonder why they phazing it out ?
either not that good a seller...or it crap....or both

asked her one for film print - she came back with a few...some way, way over the top......

this is one down the mid range end of the scale....but not got lot info on it till tomorrow...

only looks like its does 1 case at time......unless it does it in in under 2 minutes, dont see the point when you got large runs on

see pics - these are for film ONLY.... if it does like 2 cases min, i might be inserted - pending spec and price...these are brand new to the market
[ATTACH=CONFIG]2446[/ATTACH][ATTACH=CONFIG]2447[/ATTACH]

Looks very interesting BJGJ, although if I am half asleep I may end up pouring coffee in it instead

socialgiraffe;83739 wrote:Looks very interesting BJGJ, although if I am half asleep I may end up pouring coffee in it instead

LMAO...just what i was thinking when first seeing it

pends on the size..as pics sizes can be deceiving at there best - hopefully more spec later today / tomorrow....

Is this made in a factory that also makes deep fat fryers?

pisquee;83754 wrote:Is this made in a factory that also makes deep fat fryers?

I was thinking that, looks a awful lot like the Philips air fryer

lol....

looks can be very deceiving gents

will get spec tomorrow.....
would fit nice with my appliances in the kitchen tho

looks to me to only be doing 1 case at one time....and its film ONLY...

but one case is fine if its like 120sec cooking ( vacuum ) time from start to finish.

from what i heard the new machines dont need cooling jigs, as the cooking temp is a lot lower than normal 3d vacuum sublimation - so...

print then straight out to sell/pack......

but this company have another 3 /4 3d machines they gonna get specs over to us...so will see what come out of it....hopefully a decent priced, decent spec 3d machine for us ...ITS TIME

Looks very interesting but to echo above comments, does look like my chip machine that went back! lol...keep us updated

Could well be based on the same machine bit if it has a vacuum and is film based then why not? I'd expect 6 mins+ print time.

[ATTACH=CONFIG]2448[/ATTACH]

Stop posting the images guys, you are making me very hungry... LOL!!!!

socialgiraffe;83760 wrote:Stop posting the images guys, you are making me very hungry... LOL!!!!

[ATTACH=CONFIG]2449[/ATTACH]

chips with your sub machine sir