DSF

I've been trying to do lighters but cannot get the design in the middle, is there any way I can overcome this, I'm using cpm6.2. Have no trouble in using the paper but its to thick to see through the paper to place it in the right place.

jennywren;70369 wrote:I've been trying to do lighters but cannot get the design in the middle, is there any way I can overcome this, I'm using cpm6.2. Have no trouble in using the paper but its to thick to see through the paper to place it in the right place.

Create an oversize rectangle around the image so the image is in the middle of it. Then you'll know that the image is positioned ok.

Why is something so simple as a lighter just won't work for me, I'm ready to set fire to the flipping lot, going to try again today. might just stick to engraving the blasted things. But am going to give it another try.