DSF

Does anybody know if it is possible to get lapel style pin badges for sublimation and if so has anybody tried them.

Haven't used them, but seen them on BMS website

http://www.sublimetal.co.uk/?wpsc_produ ... ame-badges

May be something of interest here?

Unfortunately I just took a look on the BMS site and they do some ID style badges, however they are not really what I am looking for.
The ideal badge would be about 25 to 30 mm in diameter with either a safety pin type catch or the screw pin type used on some lapel badges.

I can make 25mm badges, one offs to many thousands. A bit of a pointless exercise trying to sublimate them, be like inventing the wheel again.

Hi
I use the lapel badges from Nova chrome they do them in the pin or magnetic type and silver or gold finish they also do matching tiepins and cufflinks I use them on a regular basis and have never had any problems with them they print well and look good when finished. Hope this helps.

Regards,
Sammy.