DSF

Hi,
I have a Stahl Hotronix Maxx heat press and have noticed the left/right alignment of the top platen is out compared to the lower one.
I can push one of the corners in a centimetre or so as the top platen 'floats' but obviously this would prove awkward when the press is on !

Is there an adjustment i can do to correct this ?

Hi,
Before posting here i went to live support at Stahls website, and they gave an email addy at hotronix.
So i emailed them last Thursday, so i will see if they get back to me. Its probably not a priority for them as the press does work ok, but i'd be happier if it was straight !

regards
Neil