DSF

Is it me just being stupid (Not completely out of the question)

Or has anyone else's cameo not cutting properly after updating to the latest software??

Just cut some vinyl, and it cut straight through!! Have just spent another 2 hours trying to get the settings right again

It happened to me once with my chinese cutter. Start cutting and then after few seconds dlade when acros the vinyl completly ruin it!
All i did was uninstall and instal cutter driver again and it helped.

Thanks Paul,

sorted now, once i had finished sulking, had a baileys coffee and chilled out, she has thought better of herself and decided to play the game and work properly.......

All is calm now in the house lol

I think there has been a lot of posts about how the settings changed dramatically with the latest updates. However I think most said they had to increase settings to get a cut which is obviously safer than cutting too deep - well I hope you get it all sorted soon.

I updated mine the other day then run a bit f vinyl though it and it cut fine until it got to the bottom and then started cutting like it was drunk