DSF

Hi again guys, I've been playing around with printing mugs for a few days and they have come out ok.
Although I have noticed the top, bottom and near the handle seem to fade out toward the edges.

am I doing something wrong

I cook at 180 and cook for 180 seconds is this right?

cheers guys

Griff

How close are you printing to the handle. It could also be the pressure being too light

I found that printing near the edge was inconsistent because of heat loss, the edges not being straight etc .... I did start turning the mug half way through - dont know why, but it did resolve the problem - in the end though I just made designs a bit smaller...

Thank you both, I have tightened the press and will try printing away from the handle

Cheers
griff