DSF

lost camera lead yesterday - so could not upload. But put my offerings in the Gallery now and supposedly edited them but cannot see where that bit went ....
So - my main problem is the edges - on the Oil company mug, I think the front looks fine but the indigo on the frame runs to a wishy washy lilac on the outer edges. What have I done wrong?
http://www.dyesubforum.co.uk/vbforum/al ... albumid=14
thanks ...
oh and zombie cat has "I can has brains?" in tribute to - I can haz cheezeburger - lol cats.
Any advice - welcome

I think the end is to close to the handle so the heat isnt getting around the image properly. can i ask where do you get your images from, I have a licence for Koolart and also have a t shirt software that comes with pictures but am after similar ones to yours

you done really well esp on the snowman and to get it to the bottom
most ppl leave a 5mm gap top and bottom as it's a real pain in the rear to get it to look right
it's the same around the handle always try and avoid that area

they are really good and great for your 1st attempts
i bet your a happy girl now hey

oh and the blue in the second picture does that have some lines on it?
that indicates a slightly blocked head
it's annoying cos it looks good on paper but when you print you can see tiny lighter lines
do a head print test that'll soon tell you if the head is blocked

well done