DSF

hi, ive just bought the 8 in 1 heat press from corelgraph and was wanting to find out how long you have to heat it up before pressing anything, also would i have to use any teflon sheets with it as well.

thanks
malcolm

I got 5in1 i bought years a goooo and it takes about 10-15 minutes to heat up main element (flat bed). there is a temp display so dont waorry you will know exactly when is heat up to your temp. also I would recomend to use teflon sheet or grease proff paper to keep your press clean.

thanks for the reply paul, ive not used it yet but will have a go tonight thanks again.

malcolm

hi paul i just did my first placemat that i bought from bms and it came out perfect except that the middle of the placemat was bowed any ideas why this would happen i pressed it at the settings on bms webpage 185c and 50 -60secs have you any ideas how to avoid this.

thanks
malcolm

they do bend a bit. you need to put something heavy on them stright after you press them. thats what other recomend any way

thanks for that reply paul cheers

hakuna;22363 wrote:hi paul i just did my first placemat that i bought from bms and it came out perfect except that the middle of the placemat was bowed any ideas why this would happen i pressed it at the settings on bms webpage 185c and 50 -60secs have you any ideas how to avoid this.

thanks
malcolm

FAQ on this matter at...
http://www.printerowners.co.uk/faq/12/1/sublimation-advanced.htm