DSF

Hi guys,

Quick question. When in printing preferences, do you choose text or photo in 'quality option' I'm getting gaps. I've done 3 nozzles and cleans.

Regards

George

always photo or best photo

ok thanks Paul. Images are really faded and colorless.

do`nt do more than three cleans, leave the printer for an hour or so and them do further cleans

Not a quick question any more
Now my images are greenish. NIIIIIIIGGHHHTMARE

Do you have your profile installed? Have you tried to press anything yet?

Hi Justin, I installed my profile, then I had probs with the printer, kept getting the red light so in the end the transfer press sent me a new cartridge which I installed a couple of hours ago. It was a nightmare getting them to click and to be fair I'm not convince they all clicked in. Anyway, the printer recharged and all seemed well until I made my 1st print. Really faded images photo) and green. I have just realized that my images are not mirrored now so is this due to changing cartridges, should I re-install the profile do you think?

Thanks again

no. I think you should get your carts out and fit them back while make sure they all "click". you said you printed nozzle chek and cleaned your heads but you never mentioned how they looked like. is nozzle print ok now???

Yeah Paul, all seemed ok with the nozzle check.

so if nozzle is ok it means carts in place too
so you say all prints look to green? are they to green after you press them too? or only on paper?