DSF

Hi

just bought a 53" cutter from a guy but didn't come with driver

It has on screen rabbit and on back the number says 1360 after googling i think it's a HX1360 rabbit cutter but i can't find the driver

Can anyone help i've attached some pics

Which software package are you using for cutting?

If you have FlexiPro, you shouold find the driver in there.

You could try contacting the manufacturers for the driver, if googling for it fails

http://rabbitlaser.en.made-in-china.com ... 1360-.html

Just found this, does it help?

http://aspgfx.com/download/rabbit+hx-13 ... +free.html

I clicked the first link and it wanted to install the required driver, afaik

Kaz;15946 wrote:Just found this, does it help?

http://aspgfx.com/download/rabbit+hx-13 ... +free.html

I clicked the first link and it wanted to install the required driver, afaik

Just clicked link you can only download if you sign up to website

Kaz;15945 wrote:Which software package are you using for cutting?

If you have FlexiPro, you shouold find the driver in there.

You could try contacting the manufacturers for the driver, if googling for it fails

http://rabbitlaser.en.made-in-china.com ... 1360-.html

Hi Kaz

I'm going to use Artcut 2009 if i can, i've just sent company email to see if i can get driver if not i'm just gonna sell it can't be chewed with it

Found this site aswell

http://www.eurosystems.lu/index.dml?unt ... prache=eng

Might be better selling ti on if no joy with locating a driver for it.

I had similar problems with my Liyu, couldn't get a driver, but Vista recognised it as being a roland, if memory serves me right.

If artcut 2009 is the same on set up as the 2007 try open manufactors click on others then HPGL or DMPL your cutter should use one of these commands.