DSF

Not sure if this is the right place to put this thread, but what software would recommend, I have been looking at design master.

FlexiSTARTER 8.5
powerfull and simple

jennywren;15193 wrote:Not sure if this is the right place to put this thread, but what software would recommend, I have been looking at design master.

Isn't Design Master only for Craft Robo's ? I have it but don't like it, I use the standard Robo software

I didn't realize that, stupid question what is the standard robo software called and will it work with any cutter, will read up about the Flexistarter.8.5. I need something simple

what is the standard robo software called and will it work with any cutter

It's called ROBO Master Software and only works on the Graphtec ROBO & ROBO Pro. I don't think other cutter plotters will open the GXD files that this software creates.

jennywren;15202 wrote:I didn't realize that, stupid question what is the standard robo software called and will it work with any cutter, will read up about the Flexistarter.8.5. I need something simple

Sorry if I confused it, I have a Robo

accdave;15197 wrote:Isn't Design Master only for Craft Robo's ? I have it but don't like it, I use the standard Robo software

sent you a PM mate

AdamB;15211 wrote:sent you a PM mate

sorry mate - no PM database problems .............. wouldn't send.

I was wondering if you would be selling the design master software (if it's not registered). I have a craft robo and was looking at the software then I saw the price (ouch!).

AdamB;15214 wrote:sorry mate - no PM database problems .............. wouldn't send.

I was wondering if you would be selling the design master software (if it's not registered). I have a craft robo and was looking at the software then I saw the price (ouch!).

Unfortunatley it's already registered. Pain in the backside too because if I switch it from one pc to another it means sending off for another licence key. I do use it for one customer, but otherwise it's naff.

AdamB;15214 wrote:sorry mate - no PM database problems .............. wouldn't send.

I was wondering if you would be selling the design master software (if it's not registered). I have a craft robo and was looking at the software then I saw the price (ouch!).

Are we talking about the same software I seen it advertised at about £50.