DSF

Hi all
I have taken a huge gamble and purchased a sublimation starter kit to try to boost the revenue in our small shop. the kit contains Ricoh Printer, Dual cup press, Heat press and a 3d heat press along with lots of other bits and bobs so im pretty sure i will have lots of questions to ask so please be nice.
I have got as far as setting the printer up and im looking for a good guide to get me started can anyone please point me in the right direction?
Also paid for premium membership on here
Thanks

First advice is check the inks before putting them into the printer and then have a good look through the forum as most of the start up questions have been answerd here many times.

Good luck in your new venture.

welcome mate

Hi there and welcome to the forum. You won't find a better guide than here! Pretty much all questions will no doubt have been covered and you can use the search facility as well as the similar threads box above your posted thread.

Justin
DSF Admin