DSF

Hi! is here any one who can do it for me?? I dont have a software and sont realy know actualy what softwear I need
I got couple of simple designes i would like to print with rhinestones.

can any one help???


thanks

Paul

Fairly sure Stitch Up said he did them. Otherwise Transfer Press will do it but fairly sure they finished for Christmas today

Thanx Dave! I am not in ruc=sh with it. I dont need all transfer done. need only template so i can cut it my self. will give John a shout i think

John!!!! Whhere r you

Hi Paul, if you post the design on here, or email it to me, I'll have a bash at converting it for you

hi KAZ! thanks you for kind offer
here is the artwork
[ATTACH=CONFIG]11[/ATTACH]

Hi Paul, Do you have it as a vector I can then put it through Corel for you.

Sharon

no. no vector iam affraid .

Hi Paul

What size stones are you going to be using?

Kaz
x

good question... never done it before what you recomend? 3mm?? or too big/small?

I use 3mm ones, but looking at your logo, I'd say you could use 3 and 4, 4 for the centre part of the lines under the KKM.

Have you got everything else you're going to need for doing the templates? i.e stencil film and application film?