DSF

Looking for a supplier of stick flags
About A4 size, ideally on a stick , light weight 100% poly so I can sub them A4 and the design show right through.
About 100
Maybe I could make them?
Any suggestions?
thanks
phil

The Transfer Press do various grades of polyester fabric by the metre or roll. I've got 3 different grades at home and the lightest/cheapest would do the job well. If you print one side the other will definitely show through but will, of course, be reversed.

i was worried that if i just cut polyester up, the edges would fray ....?

logobear;130462 wrote:i was worried that if i just cut polyester up, the edges would fray ....?

They definitely will fray logo. Most of the blanks I have seen have stitched edges -



You'd probably need to stitch the 'tubed' edge that fits onto the pole in any case.

yes, thats the sort of thing looking for, i just cannot be bothered to do all the sewing up !

That pic is from the Transfer Press but I see they are out of stock.

ready-range do some nice flags but they don't go as small as A4 their smallest flag is 25cm by 35cm.

I got some patches from them and they were pretty good. I need to get more all those gamers love their badges

Ready Range are too good, its just a cheap wavy flag, almost disposable that i am after, and on a stick...
I suppose i could get 1,000,000 from Alibaba, - but I only want 100

https://www.printequipment.de/en/sublis ... cs-carton/

Maybe this is of some help. Mario ( Printequipment) is on here sometimes.

DO you have a Roland?

If yes why not get some flag material and print directly on to the flag. If you need to hem them it would be really easy etc. etc.

S>