Page 1 of 1
Re: Setting up photoshop to output 4 coasters in a jig
Posted: 26 Nov 2017, 13:32
by firstcma
Hi All
Does anyone know of a link to download a 4/6 piece 90cm square coaster photoshop template that I can place my images in, I have a jig being made at the moment, free would be great but willing to buy.
Thanks in anticipation Mike
Sent from my iPhone using Tapatalk
Re: Setting up photoshop to output 4 coasters in a jig
Posted: 26 Nov 2017, 18:06
by webtrekker
Surel it would depend on the dimensions of your jig. You'll need to make your own template or draw up a layout and get someone to do it for you from your measurements.
Re: Setting up photoshop to output 4 coasters in a jig
Posted: 26 Nov 2017, 18:08
by firstcma
It’s A4 for a sawgrass printer, thanks Mike
Sent from my iPhone using Tapatalk
Re: Setting up photoshop to output 4 coasters in a jig
Posted: 26 Nov 2017, 19:38
by Tubstar
It would be the measurements of the jig that would be needed. There is a link on the xpres sire for a template for their 6 coaster jig. But unless yours is made with the coasters in exactly the same place its as much help as I chocolate fireguard.
Alex.
Re: Setting up photoshop to output 4 coasters in a jig
Posted: 26 Nov 2017, 19:41
by firstcma
Thanks Alex I will check it out
Cheers Mick
Sent from my iPhone using Tapatalk