DSF

I have come across an issue and wondered if anyone else has had it. Metal panels sublimated fine now a few days later customer telling me that the white coating is coming away. Please help

Where did you buy them from? Are you sure they are sublimation panels?


Sent from my iPhone using Tapatalk

I bought them from subliblanks

Sound simple but did you remove any protective film that may have been on them? Have you seen any images of the coating coming away?



Sent from my iPhone using Tapatalk

Is it the edges chipping away?

Getting one tomorrow to look at. It is not just a small piece that has come away. Procedure was followed as always removing film before pressing. Would dropping them or knocking them cause this. (Looking at everything now). I've checked the panels I have left and they seem fine. (Unprocessed ones)