DSF

EDIT - justin can you merge post this with the other one i just found please

anyone tried one yet ?

not the pneumatic ones - this one >>>


http://www.ebay.co.uk/itm/Coral-2-1-Mug ... 4d4b875fdc



also just found pauls review here >>

https://youtu.be/DLMh_3rmY1Y

one guy commented -
"Avoid buying this mug press. The front part is made of plastic and when you press the mug the plastic part also moves and there is not enough pressure on the mug."

so is it any good paul ?

one way to find out....just bought one from coralgraph now

Been looking at this recently but saw them on ebay for £70 just not sure if it was off a proper company.

Mugshots;119447 wrote:Been looking at this recently but saw them on ebay for £70 just not sure if it was off a proper company.

will let you know how this one goes..should be here on thursday coming
at least if a problem, henry is more accommodating..i hope....pauls review looked good, as others i had seen so, we will see

FOR GODS SAKE DONT BUY ONE FROM SIGNZWORLD..it will only last less than 40 mugs

well, its arrived quicker than i thought...cheers henry if you read this

excuse my crappy camera phone focus....its on its last legs and ready for the hammer

this machine has a large rubber sucker on the bottom, in the middle and stops it moving around, which is good.

now to dig out the mugs that were not fit for public sale and trial...since it pretty dead sales wise just now

Is that the throttle on the right and the brake on the left bigj?

Looks the business though. I'd like to hear how you get on with it.

I see folk complaining about plastic panel at the front moving so pressure difficult?

We were really surprised by these presses, one of our staff member has even bought one to use to do mugs for family and friends! We weren't sure to start with but have got good & consistent results during tests.
Adam did a intro video for them a while back:

https://www.youtube.com/watch?v=rNskqM8fnlw

Justin;119510 wrote:I see folk complaining about plastic panel at the front moving so pressure difficult?

UPDATE :
prints are superb - full top/bottom no bother at all....
yes the front panel is kinda plastic, and DOES FLEX when you put in mug and tighten it.
but it in no way affects the pressure of mat around the mug at all.

set up :
idle time 110
print temp 180
print time 195

will get some samples done and fire em up here

paul had difficult in finding how to set idle time in his vid review....it there, and easy to do