DSF

Just thought I'd mention this if you dont know already and if you have grubby cutting mats and are thinking of binning and getting new ones.

I went over to MDP yesterday and he gave me a cool little tip, I have 2 cutting mats which are a bit worse for wear, covered in crap and grime etc, he said just to give them a wipe with baby wipes, wait 10 minutes and give them another wipe etc etc until clean.

I have given mine 3 good cleans with baby wipes and it worked, took off a lot of crap to and also brings back the tac, not quite as taccy as a new mat but it did the job!

This is the best stuff I've found - https://www.crafterscompanion.co.uk/sti ... e-can.html completely removes all traces of adhesive.

Once cleaned, respray with 3M ReMount spray - https://www.amazon.co.uk/3M-ReMount-Spr ... B000I6PM7W available at other places much cheaper than Amazon but still around the £17 mark. Great stuff though.