DSF

Just bought a few samples items from Subliblanks to take a look at. The PU Leather keyrings look very nice and print both sides.

Has anyone printed these? I'm assuming printing one side at a time but wonder if the second print would interfere with the other side?

Only have a few so wanted to ask rather than waste

Surprisingly low print temp of 150c/155c on these as well.

Best give it a quick go and post back your findings. The temp is really low so it should be fine to do each side one at a time. I would protect the bottom platen with a piece of copy paper.

Did you get good results as I just got some PU leather key ring and having problems

This post is nearly two years old. You may want to start a new thread with your issues.


Sent from my iPhone using Tapatalk

What problems are you having?

think I have sorted it needed more pressure was not getting full image on missing the edges
thanks