Page 1 of 1
Re: Geo Knight DK20S Displays Err and Beeps at switch on?
Posted: 20 Aug 2016, 11:49
by Stitch Up
Subject says it all really! Our Geo Knight DK20S Displays Err and beeps continually at switch on!
Anyone know of a resolution for this?
I'm planning on taking the board out and soldering all the joints in case it's a dry joint problem.
Cheers
John
Re: Geo Knight DK20S Displays Err and Beeps at switch on?
Posted: 20 Aug 2016, 12:39
by Adrian B
Check the Temperature sensor wire is plugged in properly first.
http://www.heatpress.net/pdf/dk20sman.pdf
Re: Geo Knight DK20S Displays Err and Beeps at switch on?
Posted: 21 Aug 2016, 10:37
by Stitch Up
Thanks for that Adrian
Before I read your reply I'd removed the cover exposing the boards, didn't see anything obviously wrong so put it back together. Switched on and 'hey ho', it worked
Cheers
John
Re: Geo Knight DK20S Displays Err and Beeps at switch on?
Posted: 21 Aug 2016, 12:37
by Andysam26467
We have a DK20S with a dodgy bleeper. When the cycle finishes sometimes it bleeps and sometimes it doesn't. It's a real pain because you have to watch it all the time. I think I'll try looking at the board for loose connections.
Not sure I'm up to soldering joints though lol
Sent from my iPad using Tapatalk