DSF

After more than a year, I finally found my mug press! It was nicely packed in a plastic box with the instructions

This is the press - anyone recognise it?
In the instructions it tells me to set the temperature to 230degF for mugs and much higher for aluminium water bottles - somewhere near 300 from memory.

When I switch the mug press on, the display reaches 150 and starts beeping. Press the Mode button and I can't raise the temperature any higher than 220deg. I'm left wondering whether my press is set to centigrade and not Fahrenheit!

If someone has any knowledge of this heat press, any instructions, advice or whatever, I'd like to hear from you

Cheers

John

It looks similar to mine so if it only adjusts to 220 it is in centigrade I'd try a mug at 180 and see how it goes'I'm not sure if yours is a manual start to the timer but mine has a micro switch on the lever.

Thanks for the reply and I'm sort of hoping you're right and it is displaying centigrade!

I have a suspicion the timer did start when I closed the press lever - something for me to confirm later.

If you have a manual in pdf or other e mailable format, I'd be very grateful for a copy

Cheers

John

looks the same as the one i won from BMS in the good old days of the forum, if it is, then its good Mark my chief presser and bottle washer (husband) uses the 180/180 method ie time temp, if you get stuck pm me and i will get him to call you

we have a couple
press mode enter these and press again
110
175
80
45
works great for mugs, just give alli bottles longer after it beeps

Thanks all, a great help

If you have a manual in pdf or other e mailable format, I'd be very grateful for a copy

Sorry but I had no instructions with it.

We have a few of these as well. Good press. I think your question has been answered though but any more info let us know. Olly

Thanks Olly