DSF

After looking at the vinyl available for the craft robo and the pre cut sheets that can be purchased at 610 mm in length - surely it would be easier (and cheaper) to purchase 5m rolls of the said vinyl which are 610mm wide and cut them with a sharp knife to meet the craft robo specifications?

Does everyone else do this?

it would be easier (and cheaper) to purchase 5m rolls of the said vinyl which are 610mm wide and cut them with a sharp knife to meet the craft robo specifications?

Yeap!

thanks Martin ............ that's what I thought

It's what I do. It also gives me the option of using a metre strip when I have a few to cut.

Best advice I can give if you go down that line, get yourself a proper cutting mat, saves loads of time measuring

Thanks Dave - yeah a cutting mat is definatly on my shopping list!

I use a gulliotine, with lots of our designs saved in the robo on 500mm lengths any short bits I also use up with odd bits here n there. Very little vinyl goes to waste.