DSF

Hey all, I've been given an old Roland camm-1 cutter and was told by the chap that its no longer in use because it only supports up to xp, has anyone heard of this and is there a way round it, or should I just use a VM running xp, lastly I'm new to vinyl and wondering is this machine any good or should I stick with my old pcut cr630 thanks

Sent from my A0001 using Tapatalk

Roland all the way, I started with Pcut and upgraded to a Graphtec last year. These machines are built to do the job day in day out. I can't help about the XP part though, sorry.

my camm 1 works fine on win 8

logobear;107269 wrote:my camm 1 works fine on win 8

Hi, what drivers did you use as I was told that when they contacted Roland about the drivers, they said they was discontinued after xp for that machine
Best regards

Sent from my A0001 using Tapatalk