DSF

Hi guys,

Everything is in the topic really,
in Power Driver 4 for Sawgrass there is no option to print on to 3D film
so I was wondering if anyone have some more experience with this?

I'm doing 1st attempt with 3D sublimation today:)

thanks

I had this issue and contacted Sawgrass. They stated they don't support it so wouldn't really advice but after speaking with a couple of suppliers I just went with standard trupix setting. Seemed to work fine for me. Depending on your film you may find you have to play with how much ink to actually lay down (I reduced by a few%, can't remember how).

Ucase Ltd;105385 wrote:I had this issue and contacted Sawgrass. They stated they don't support it so wouldn't really advice but after speaking with a couple of suppliers I just went with standard trupix setting. Seemed to work fine for me. Depending on your film you may find you have to play with how much ink to actually lay down (I reduced by a few%, can't remember how).

Thanks.

How to reduce amount of ink?
Would you recommend any good film?
May I ask if you have you been sublimating 2D phone cases with thin metal inserts?




Sent from my GT-I9195 using Tapatalk

thanks all