DSF

Hi
I've bought some Bagbase wallets, tested one yesterday and the print came out fine but the polyester spine (I pressed it open, not sure if that was right?) went a bit 'melty' has anyone tried these and know what the correct settings are? (I just guessed!) they don't give any info on their website and they are a bit too pricey to keep testing

Thanks!

I press my wallets open but with only the part to be pressed in the press. with the rest hanging outside. Hope that makes sense.

yup I press one side, then the other so the spine is always just on the outside of the press

thank you, I done another with the edge hanging over as suggested and some paper taped over the spine just in case and it worked perfectly!