DSF

I was using the cap press when I went to seal the wow 7.2. transfer and forgotten to cover it and consequently the image has transferred on the top of the cap press. How do I remove it as I have a order to complete by Saturday. I have switch the cap press off and having deep breathing exercise to calm the nerves.

I normally scrunch up a piece of regular a4 paper and scrub the press area, - usually while hot. It is non stick, - will cvlean off fine, - then just press a couple of bits of paper while hot to clean off any last bits.

LOL so you've done it before then Phil

Thanks Phil, I cannot believe I did that but thanks for the advice

Thanks Phil, I cannot believe I did that but thanks for the advice

Did what you said and thank goodness it work, I took on job for a bulk order of printed caps, I knew the job was difficult and really wanted to say try some else but they pay well, I have earned my money on the job and my stress levels have never been this high and now its over it they asked me again I hope I have the sense to say NO, so once again Phil many thanks for that tip.

Wouldn't using a piece of baking paper as a makeshift layer work?

Spike1865;100220 wrote:Wouldn't using a piece of baking paper as a makeshift layer work?

I do, I got into a rhythm cap on, baking paper on top 5 secs off, but after 60ish caps, I forgot baking paper, I think my arm was killing me and I let the pain distract me and it transferred to plate

Its a very valid question, you're not stupid!