Page 3 of 3
Re: xpres keyrings
Posted: 28 Aug 2011, 21:42
by Ian M
Paul, I had the same problem with the Rhodium ID Tags. I spoke to Xpres who did a test & they replaced mine with no problem. The paper does tend to play a major part in the problem & I was using their own paper. I switched to another paper from Signal Ink Jet & they were much better.
Re: xpres keyrings
Posted: 28 Aug 2011, 21:56
by Paul
now you talkin g mate! it may be as I always use texPrint. I am going to try some other matt paper now
will let you know
Re: xpres keyrings
Posted: 29 Aug 2011, 15:15
by mugstar
I know it is slightly off thread, but i do engraving aswell as subli & i use these for engraving not printing....can do 'photo engraving' also though & they look great!
Re: xpres keyrings
Posted: 01 Sep 2011, 16:34
by Paul
I forgot about this tread
And I when with Ian route and changed texPrint hr paper for the elcheapoo one of ebay I bought ages ao!! (well... not that cheap
)
and it looks all fine now. it looks like texprint is to thin or something. this smudges look like burned coating of the paper or somethinig... any way.. All good now
Thanks Ian!
Re: xpres keyrings
Posted: 02 Sep 2011, 20:57
by Ian M
Paul;29805 wrote:I forgot about this tread
And I when with Ian route and changed texPrint hr paper for the elcheapoo one of ebay I bought ages ao!! (well... not that cheap
)
and it looks all fine now. it looks like texprint is to think or something. this smudges look like burned coating of the paper or somethinig... any way.. All good now
Thanks Ian!
Your welcome mate :biggrin:
)