ChromaLuxe Panel Printing video

bms · Post by **bms** » 13 Oct 2012, 21:07

crystaluk;56168 wrote:Looks great!! Where did you get the jig from?

5mm thick mousemat and a sharp knife (or I'm sure Paul will sell you one already cut for a lot more than the cost of a mousemat and a sharp knife

)

Paul · Post by **Paul** » 13 Oct 2012, 21:19

Lol. Yeah. Will sell jig for £10

Any one???

crystaluk · Post by **crystaluk** » 13 Oct 2012, 22:53

Paul;56171 wrote:Lol. Yeah. Will sell jig for £10

I think you added the zero by mistake? Lol! It's a superb idea so creative

stuart · Post by **stuart** » 15 Oct 2012, 08:51

thanks paul fantastic as always
do you not need to use a cover sheet on top when pressing ?
stu

Paul · Post by **Paul** » 15 Oct 2012, 09:54

Do you mean silicon?

stuart · Post by **stuart** » 15 Oct 2012, 10:30

silicon or paper
stu

Paul · Post by **Paul** » 15 Oct 2012, 11:11

Iuse teflon sheet.

stuart · Post by **stuart** » 15 Oct 2012, 13:03

just wondered cus in the video you never used anything
stu

Paul · Post by **Paul** » 15 Oct 2012, 13:15

Yes. Know. In this case there was no need as the paper was much biger then print. but normaly i would use teflo sheet. I also use copier paper .

stuart · Post by **stuart** » 15 Oct 2012, 14:58

thankyou paul
stu

DSF